16mm Illuminated Pushbutton - Red Momentary

1.97 2.38€ VAT included
Rated 0/5 (0 Votes!)
Model: ADFC-1439
Manufacturer: Adafruit
Adafruit

A button is a button, and an LED is a LED, but this LED illuminated button is a lovely combination of both! It's a medium sized button, large enough to press easily but not too big that it gets in the way of your project panel. It has a built in LED that can be controlled separately from the switch action - either to indicate or just to look good.

The body is a black plastic with the LED built inside. There are two contacts for the button and two contacts for the LED, one marked + and one -. The forward voltage of the LED is about 2.2V so connect a 220 to 1000 ohm resistor in series just as you would with any other LED to your 3V or higher power supply.

This particular button has a red body and LED and is momentary, normally open. The two switch contacts are not connected normally. When you push the button they will temporarily connect until the button is released. The LED is separated from the button, so you can make it light up when pressed, light up when not pressed, always lit, etc.

16mm Illuminated Pushbuttons (7:54)

For more information, please visit this products webpage.
More products in this category:

Buy Adafruit Europe Official Distributor »

Customers who bought this product also purchased
Getting Started with Circuit Playground Express Book Bundle
The bestselling book Getting Started with Circuit Playground Express now comes with a full pack of parts so you can hit the ground running! Getting Started with Circuit Playground Express is written by ...
73.27€
Adafruit Animated Eyes Bonnet for Raspberry Pi Pack
Give your next animatronic or robotic project the gift of eyes with this Snake Eyes Bonnet Pack for Raspberry Pi. The Snake Eyes bonnet is an accessory for driving TFT LCD displays, and it also provides four analog ...
54.71€
Makey Makey Classic Original Kit
Makes STEM Education fun! Start out easy with a banana piano. First setup takes seconds. Then make game controllers, musical instruments, and countless inventions. Advance to additional inputs and multi-key remapping up to 18 ...
49.50€ 39.75€
Raspberry Pi 3 Model B+ 2018 WiFi Bluetooth
New RaspberryPi 3 Model B+ 2018 with ARM11 Cortex-A53 64-bit 1,4 GHz This board have the same form factor as Raspberry Pi Model B+. - ARM 11 Cortex-A53 64 bits 1,4 GHz BCM2837 - 1GB LPDDR2 SDRAM - WiFi 802.11 ...
46.95€
Adafruit 16-Channel 12-bit PWM/Servo Shield - I2C interface
You want to make a cool Arduino robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts. Or maybe you want to drive a lot of LEDs with precise PWM output. Then you realize that the Arduino has only a few ...
19.17€
Adafruit METRO 328 with Headers
We sure love the ATmega328 here at Adafruit, and we use them a lot for our own projects. The processor has plenty of GPIO, Analog inputs, hardware UART SPI and I2C, timers and PWM galore - just enough for most simple projects. ...
19.17€
ProtoSnap - LilyTwinkle
Description: The ProtoSnap series is a new way to prototype your project without a breadboard. Everything is wired together on a single board, which makes it easy to explore the possibilities of the components before ...
16.14€
BarePaint Conductive Pen
Bare Paint is just like any other water-based paint... except that it's electrically conductive! This means that you can actually paint wires onto things like models, clothes, furniture, walls, almost anything you can think of. Standard ...
12.59€
Europe Official Distributor
Adafruit
Pololu
Sparkfun
Makey makey
Lilypad
Arduino

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice