Hammer Header Female - Solderless Raspberry Pi Connector

4.69 5.67€ VAT included
Rated 0/5 (0 Votes!)
Model: ADFC-3663
Manufacturer: Adafruit
Adafruit

If your soldering isn't quite up to scratch, or you just don't own a soldering iron yet, then these nifty hammer headers from Pimoroni might be just what you need. 

Absolutely no soldering required! All that's needed is a few gentle taps with a hammer and whammo! Your header is securely attached to your Pi Zero or pHAT/bonnet/HAT. Make sure to carefully read Pimoroni's guide for fitting hammer headers.

These socket headers are simpler to insert than the male headers as you can hammer straight onto the plastic of the header. (The plug-headers can be particularly tricky.) But either way they're best as an add-on to this hammer-header jig and pack

Note: Hammer at your own risk! We can't be held responsible for any damage that you may cause to your Pi Zero, bonnet, pHAT, HAT, headers, or fingers while fitting them. If you follow Pimoroni's guide carefully, you should be fine. If this worries you, then get yourself a soldering iron instead!

 

 

https://www.youtube.com/embed/KYsKa2LQc6c?start=48

For more information, please visit this products webpage.
More products in this category:
Europe Official Distributor
Adafruit
Pololu
Sparkfun
Makey makey
Lilypad
Arduino

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice