13.56MHz RFID/NFC Charm

3.29 3.98€ VAT included
Rated 0/5 (0 Votes!)
Model: ADFC-884
Manufacturer: Adafruit
Adafruit

This is a blank 13.56MHz RFID/NFC embedded in a phone charm - often used for train/bus passes but also found in other systems where a proximity card is desired. The tag contains a small RFID chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.

These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle ISO/IEC 14443 Type A cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!

These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.

These use a ISO/IEC 14443 Type A chipset, which used to be the 'classic' NFC chipset. In ~2014, the NFC forum decided not to support this chipset anymore, so newer phones do not support it. This only matters if you're trying to use this tag with a phone/tablet.

For more information, please visit this products webpage.
More products in this category:

Buy Adafruit Europe Official Distributor »

More Featured Products
Arduino Starter Kit Spanish Edition
Oficial Arduino Kit with 15 projects of different complexity. 1 Arduino Projects Book Spanish Edition (170 pages) 1 Arduino UNO board rev 3 1 USB cable 1 Breadboard 1 Easy-to-assemble wooden base 1 9v ...
82.60€ 65.08€
Lithium Ion polymer Battery 1A
This is a light weight, high energy density Lithium Ion polymer battery. It outputs a nominal 3.7v at 1000mAh, comes terminated with a standard 2-pin JST connector- 2mm spacing between pins. Features: Excellent ...
9.45€
Speed Regulator DC 12-40V 10A
This Pulse Width Modulation Module can be used to adjust the duty of PWM range from 10% to 100%. The max. output current can be up to 10A to ensure a large torque, can be widely used in industrial production. Working Voltage: ...
9.75€
LilyPad Coin Cell Battery Holder - Switched - 20mm
Sure, your flashing, chip-tune playing T-shirt is really cool at the party… but at some point you need to turn it off. And yes, you could just pull the battery, or maybe you’ve even sewn a LilyPad slide switch in-line. Wouldn’t it be ...
2.23€
Raspberry Pi 3 Model B+ 2018 WiFi Bluetooth
New RaspberryPi 3 Model B+ 2018 with ARM11 Cortex-A53 64-bit 1,4 GHz This board have the same form factor as Raspberry Pi Model B+. - ARM 11 Cortex-A53 64 bits 1,4 GHz BCM2837 - 1GB LPDDR2 SDRAM - WiFi 802.11 ...
46.95€
Europe Official Distributor
Adafruit
Pololu
Sparkfun
Makey makey
Lilypad
Arduino

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice