This is SparkFun Beefy 3 FTDI Basic Breakout for the FTDI FT231X USB to serial IC. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 3.3V Arduino boards. It can also be used for general serial applications. Built upon the same foundation as our 3.3V SparkFun FTDI Basic Breakout, the Beefy 3 is equipped with an AP2112K voltage regulator making this FTDI basic breakout board capable of handling a current load of up to 600 mA! With the addition of a more “Beefy” voltage regulator your will now be able to power a 3.3V project directly from the FTDI. The pinout of this board matches the FTDI cable to work with official Arduino and cloned 3.3V Arduino boards.
This board brings out the DTR pin as opposed to the RTS pin of the FTDI cable. The DTR pin allows an Arduino target to auto-reset when a new Sketch is downloaded. This is a really nice feature to have and allows a sketch to be downloaded without having to hit the reset button. This board will auto reset any Arduino board that has the reset pin brought out to a 6-pin connector. The pins labeled BLK and GRN correspond to the colored wires on the FTDI cable. The black wire on the FTDI cable is GND, green is DTR. Use these BLK and GRN pins to align the FTDI basic board with your Arduino target.
There are pros and cons to the FTDI Cable vs the FTDI Basic. This board has TX and RX LEDs that allow you to actually see serial traffic on the LEDs to verify if the board is working, however this board now requires a Micro-B USB cable. The FTDI Cable is well protected against the elements, but is large and cannot be embedded into a project as easily. The FTDI Basic uses DTR to cause a hardware reset where the FTDI cable uses the RTS signal.
This board was designed to decrease the cost of Arduino development and increase ease of use (the auto-reset feature rocks!). Our Arduino Pro and LilyPad boards use this type of connector.
Documents:
50% DESCUENTO SOLO hasta fin de existencias. Añade el producto al carro y aumentando la cantidad podrás ver cuantas unidades quedan ...
Esta cinta de cobre permite variedad de aplicaciones, desde crear pistas para componentes electrónicos a fabricar antenas. Ancho 5mm. Longitud: 15m.50% DESCUENTO SOLO hasta fin de ...
El material conductivo velostat (o también conocido como Linqstat) es sensible a la presión, al doblarlo o arrugarlo disminuye su resistencia con lo que permite hacer sensores flexibles. Dimensiones 28 x ...
Este kit incluye: Micro:bit V2 Cable USB corto Portapilas para 2 pilas AAA 2 pilas ...
Crea un hogar inteligente programando con micro:bit. Puedes usarlo para crear muchos proyectos diferentes, como un ventilador inteligente, luces activadas por voz, ventanas automáticas y más. Se adapta a la programación gráfica de ...
El Robot Maqueen para Micro:bit de DFRobot está diseñado específicamente para fomentar el interés de los niños en la ciencia y el pensamiento lógico a través de la educación STEM. ...
Incluye La placa Micro:bit V2 y el robot Maqueen El Maqueen es un robot de programación ...