Thermocouple Type-K Glass Braid Insulated Stainless Steel Tip

11.99€ 14.51€ VAT included
Rated 0/5 (0 Votes!)
Model: ADFC-3245
Manufacturer: Adafruit
Adafruit

Thermocouples are best used for measuring temperatures that can go above 100°C. This is a bare wires stainless-steel tip probe which can measure air or surface temperatures. Most inexpensive thermocouples have a vinyl covering which can melt at around 200°C, this one uses a fiberglass braid so it can be used in high temperature measurements such as heaters and ovens. There's a small piece of heat shrink on the connector ends of the wire to keep the fiberglass from fraying, and a 2 cm long  stainless steel probe on the opposite end.

  • K type thermocouple with glass over-braiding
  • Good up to 500°C (900°F)!
  • Color-coded wires
  • 1 meter long (a little more than 3 feet)
  • Best used with a thermocouple amplifier such as the MAX31855, AD8495 or MAX31856

We have a handy tutorial which covers thermocouple use including both CircuitPython & Arduino libraries and example code! Also make sure to check the guide for the thermocouple amplifier you choose.

 

For more information, please visit this products webpage.
More products in this category:
Europe Official Distributor
Adafruit
Pololu
Sparkfun
Makey makey
Lilypad
Arduino

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice