Stereo Bonnet Pack for Raspberry Pi Zero W - Includes Pi Zero W

46.60 56.39€ VAT included
Rated 0/5 (0 Votes!)
Model: ADFC-3412
Manufacturer: Adafruit
Adafruit

Remember those cereal commercials that would always say, "part of a complete breakfast"? Well the Pi Zero's a lot like that bowl of cereal - while it's great on its own, you need a lot of accessories to make it a complete meal. 

The Pi Zero Stereo W Bonnet Pack sets you up with the WiFi-enabled Pi Zero W, and our I2S 3W Stereo Speaker Bonnet. This bonnet uses digital sound standard I2S right on the 2x20 pin GPIO header, providing really crisp audio. The digital data goes right into the amplifier so there's no static like you hear from the headphone jack. And it's super easy to get started. We even include speakers that you can plug right in! Once you've set up your Pi Zero, run our installer script, reboot and you're ready to jam!

Note: Due to popular demand, there might be some delay in shipping products containing Pi Zero W!

Our tutorial will get you set up with instructions, you'll be rockin' out in 15 minutes.

This pack includes:

Don't forget to make sure you have a good strong 5V power supply - especially if you're using the 3W 4 ohm speakers at full blast! Our 2.4A power plug is recommended and not included.
You'll also need a microSD card with NooBs or other Raspberry Pi operating system software, also not included.

Some light through-hole soldering is required to attach the headers onto the Pi Zero and Bonnet. A soldering iron and solder are required to perform this task.

For more information, please visit this products webpage.
More products in this category:

Buy Adafruit Europe Official Distributor »

More Featured Products
Arduino UNO Rev3 Original with ATMega328
Arduino is an open-source physical computing platform based on a simple i/o board and a user friendly development environment that implements the Processing/Wiring language. Arduino UNO is the enhanced release of Duemilia ...
22.45€ 18.95€
Micro Servo SG90 9g
This is the most mini servo. Only weights 9 gram and gives you a 1.6kg.cm torque. Pretty strong regarding its size. General specifications - No load speed: 0.12 seconds / 60 degrees (4.8V) - Stall Torque: 1.6 kg / cm ...
4.70€
Conductive Thread - 60g (Stainless Steel)
Description: This is about 360 yards of conductive thread spun from stainless steel fiber and wound on a spool. You can use it as a creative way to connect various electronics onto clothing projects. This large spool ...
52.52€
NodeMCU V3 IOT ESP8266 development kit
The NodeMcu is an open-source firmware and development kit that helps you to Prototype your IOT product within a few Lua script lines. Features: Open-source Interactive Programmable Low ...
5.75€
Ultrasonic Range Sensor HC-SR04
This is a non-contact distance measurement module. It’s designed for easy modular project usage with industrial performance. Features: - Detecting range: 2cm-4m - Best in 15 degree angle - 5VDC power supply - ...
2.13€
70:1 Metal Gearmotor 37Dx70L mm with 64 CPR Encoder
This gearmotor is a powerful 12V brushed DC motor with a 70:1 metal gearbox and an integrated quadrature encoder that provides a resolution of 64 counts per revolution of the motor shaft, which corresponds to 4480 counts per revolution of ...
33.29€
Europe Official Distributor
Adafruit
Pololu
Sparkfun
Makey makey
Lilypad
Arduino

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice