Sparkfun

Displaying 1 to 100 (of 143 products)
VAT not included
SPRK-DEV-14336
23.45€
The micro:bit is a pocket-sized computer that lets you get creative with digital technology. You can code, customize and control your ...
SPRK-DEV-14208
21.75€
The BBC micro:bit is a pocket-sized computer that lets you get creative with digital technology. Each order contains just the micro:bit ...
59.75€
The SparkFun Inventors Kit (SIK) for micro:bit is a great way to get creative, connected and coding with the micro:bit. The SIK for ...
1.14€
Three pin JST connector with red, black, and yellow colors. 5 inch wire outs. This cable comes fully assembled as shown and connects ...
SPRK-PRT-09279
0.46€
SPRK-SEN-10264
7.95€
A simple flex sensor 2.2" in length. As the sensor is flexed, the resistance across the sensor increases. The resistance of the flex ...
SPRK-PRT-09280
0.46€
SPRK-ROB-11015
4.54€
Description: Solenoids are a great way to induce linear motion for pushing, pulling or controlling switches and lever
6.10€
This is a force sensitive resistor with a round, 0.5" diameter, sensing area. This FSR will vary its resistance depending on how much ...
9.70€
Infrared proximity sensor made by Sharp. Part # GP2Y0A21YK has an analog output that varies from 3.1V at 10cm to 0.4V at 80cm. The sensor ...
1.53€
Features: - Voltage Input: 2.7 V to 5.5 VDC - 10 mV/ΊC scale factor - +/-2ΊC accuracy over temperature - +/-0.
5.49€
Dimensions: 83.5 x 54.5 x 8.5mm. Self-adhesive on the back
6.95€
If you need to charge LiPo batteries, this simple charger will do just that, and do it fast! The SparkFun LiPo Charger Basic is stripped ...
1.14€
This is a small 12mm round buzzer that operates around the audible 2kHz range.
SPRK-PRT-08272
0.53€
Description: This is a 10-pin socket with 2mm pitch that mates with the popular XBee radio fro
2.29€
This adapter allows you to connect a barrel jack connector to bare wires. One end has screw terminals and the other has a 5.5x2.1mm, ...
2.44€
This is a high quality jumper cable. Hand made with 22AWG multistrand wire and sturdy male pins. Each jumper cable has an approximate 150mm ...
SPRK-PRT-09353
6.10€
Includes 95 pieces of heat shrink, all of varying colors and sizes, and comes in a clear bag. All pieces are 10cm in length  ...
SPRK-COM-10722
0.87€
Description: If you want to get some sound out of your project but have a tight space budget, this is a good way to d
11.44€
Description: The RHT03 (also known by DHT-22) is a low cost humidity and temperature sensor with a single wire digita
6.10€
These are very thin variable potentiometers. By pressing down on various parts of the strip, the resistance linearly changes from 100Ohms ...
9.15€
1/4th Watt, +/- 5% tolerance carbon film PTH resistors. Comes with 25 of each value: 0Ω, 1.5Ω, 4.7Ω, 10Ω, ...
SPRK-ROB-12859
18.31€
The Big Easy Driver, designed by Brian Schmalz, is a stepper motor driver board for bi-polar
9.75€
This is a light weight, high energy density Lithium Ion polymer battery. It outputs a nominal 3.7v at 1000mAh, comes terminated with a ...
SPRK-ROB-10846
18.31€
These steppers are a great way to get things moving, especially when positioning and repeatability is a concern. Fea
SPRK-ROB-10398
16.78€
Description: This vacuum pump really sucks! This pump operates at 12V and has enough suction for most small projects.
10.68€
The SparkFun Load Cell Amplifier is a small breakout board for the HX711 IC that allows you to easily read load cells to measure weight. ...
SPRK-COM-13247
2.70€
This is the Magnetic Door Switch Set, a small reed switch assembly specifically designed to alert you when doors, drawers, or any other ...
SPRK-COM-08644
0.87€
Description: These are very small rare earth magnets - 0.125" cubed. Composed of Neodymium/Iro
1.38€
Description: These are small rare earth magnets - 0.25" cubed. Composed of Neodymium/Iron/Boro
SPRK-COM-12062
2.70€
Description: We all know that you can never get too many LEDs. Don't worry, we've
3.81€
Because they are digital, you don't get any signal degradation even over long distances. The DS18B20 provides 9 to 12-bit (configurable) ...
SPRK-COM-11521
12.59€
Bare Paint is just like any other water-based paint... except that it's electrically conductive! This means that you can actually paint ...
13.20€
The SparkFun MPU-9250 IMU Breakout features the latest 9-axis MEMS sensor from InvenSense. Each of these 9DoF breakouts feature an ...
9.34€
This straight bar load cell (sometimes called a strain gauge) can translate up to 10kg of pressure (force) into an electrical signal. ...
15.54€
Description: An assortment of colored wires: you know it's a beautiful thing. Six different colors of solid core wire
13.73€
Breakout board for the 3 axis ADXL335 from Analog Devices. The ADXL335 is a triple axis accelerometer with extremely low noise and power ...
SPRK-WRL-11812
23.15€
This is a simple to use, USB to serial base unit for the XBee line. This unit works with all XBee modules including the Series 1 and Series ...
3.43€
Dip 8 20MHz 8K 6 I/O 4ADC 10 bit
SPRK-DEV-13736
21.80€
The Teensy is a breadboard-friendly development board with loads of features in a, well, teensy package. Each Teensy 3.2 comes ...
5.95€
This is a small force sensitive resistor. It has a 0.16" (4 mm) diameter active sensing area. This FSR from Interlink Electronics will ...
11.44€
This is a force sensitive resistor with a square, 1.75x1.5", sensing area. This FSR will vary its resistance depending on how much pressure ...
17.45€
Copper tape has countless applications in electronics from creating low-profile traces for electrical components to RF-shielding and ...
SPRK-WRL-11373
9.15€
The XBee Explorer Regulated takes care of the 3.3V regulation, signal conditioning, and basic activity indicators (Power, RSSI and DIN/DOUT ...
30.51€
The MP3 Shield wires your Arduino up to a VS1053B MP3 audio decoder IC, providing it with the ability to decode audio files. The VS1053 is ...
SPRK-COM-08642
1.79€
Description: This is a small device called a
SPRK-TOL-10950
10.68€
Polymorph is a non-toxic, biodegradable polyester with a low melting temperature of about 60ΊC (140ΊF). Prototype plastic parts can be made ...
SPRK-ROB-11696
1.53€
Description: This is our new Hobby Motor now with a 6mm, 10 tooth, gear to make your basic projects a little simpler
9.92€
It’s blue! It’s thin! It’s the Arduino Pro Mini! SparkFun’s minimal design approach to Arduino. This is a 3.3V Arduino running the 8MHz ...
8.59€
This is the half-sized Raspberry Pi Perma-Proto Breadboard from Adafruit, a simple solder-able-type bare PCB kit that affords you with ...
6.77€
The ScrewShield extends all pins of the Arduino out to 3.5mm pitch screw terminals. It also has a lot of the utility provided by Arduino ...
13.73€
The 7-Segment Serial Display turns the thirteen pins necessary to control a 4-digit 7-segment display into just one or three. The display ...
9.92€
Arduino Pro Mini does not come with connectors populated so that you can solder in any connector or wire with any orientation you ...
38.45€
Description: This is about 360 yards of conductive thread spun from stainless steel fiber and wound on a spool. You c
SPRK-BOB-13263
12.15€
Introducing the 3.3V SparkFun FT231X Breakout board, complete with the full UART hardware handshake feature! The pin-out of this board ...
13.73€
This is a basic breakout board for the FTDI FT232RL USB to serial IC. The pinout of this board matches the FTDI cable to work with official ...
3.43€
Dip 14 20MHz 8K 12 I/O 8ADC 10 bit
0.89€
Sometimes referred to as “spade connectors,” these quick disconnects are really useful as power connectors in prototyping or in projects ...
8.39€
The Raspberry Pi is everybody’s favorite little computer and adding a Camera Module or Pi NoIR opens the door into video and photo ...
SPRK-COM-09998
0.87€
Knobs are a great way to finish off your project and make it easier to adjust the level of your death ray. This knob mates to a 0.25" ...
19.83€
This shield allows you to use a computer power supply (or other power source) to use your Arduino to switch high current. With RFP30N06LE ...
SPRK-ROB-10551
8.39€
These small steppers are a great way to get things moving, especially when positioning and repeatability is a concern.
72.90€
This 7" Raspberry Pi Touchscreen LCD provides you with the ability to create a standalone device that can be utilized as a custom tablet ...
SPRK-DEV-10116
22.88€
The Arduino Funnel I/O (Fio) is a board designed by Shigeru Kobayashi, based on the original design from LilyPad. Funnel is a ...
12.21€
LCD with White Led backlight. Vin: 5V. HD44780 parallel interface chipset.
10.68€ 5.87€
The Raspberry Pi Model B+ is THE new favorite of development platforms, so the last thing that you'd want is for something bad ...
SPRK-BOB-09118
4.58€
13.45€
This straight bar load cell (sometimes called a strain gauge) can translate up to 5kg of pressure (force) into an electrical signal. ...
13.73€
The microSD Shield equips your Arduino with mass-storage capability, so you can use it for data-logging or other related projects. There is ...
5.26€
The TMP102 is a digital sensor, has a resolution of 0.0625°C, and is accurate up to 0.5°C.The sensor requires very low-current, and is ...
25.94€
This easy to assemble kit gives you all the parts necessary to assemble a serial 16x2 character LCD display
SPRK-DEV-09718
16.02€
The FTDI cable is a USB to Serial (TTL level) converter which allows for a simple way to connect TTL interface devices to USB. The I/O pins ...
22.87€
This is the Sunny Buddy, a maximum power point tracking (MPPT) solar charger for single-cell LiPo batteries. This MPPT solar charger ...
13.73€
The serial enabled LCD backpack allows you to control a parallel based LCD over a single-wire serial interface. The SerLCD backpack takes ...
SPRK-KIT-12867
18.31€
This board will let you take advantage of your ATX power supply to create a benchtop power supply. You'll have access to four different ...
SPRK-DEV-10915
13.73€
Arduino Pro Mini does not come with connectors populated so that you can solder in any connector or wire with any orientation you ...
SPRK-BOB-14021
2.15€
This is the SparkFun RJ11 Breakout, two simple breakout boards for the common 6-pin RJ11 connector. These little boards can easily have ...
SPRK-TOL-10410
41.19€
0.89€
Sometimes referred to as “spade connectors,” these quick disconnects are really useful as power connectors in prototyping or in projects ...
36.62€
The MicroView is the first chip-sized Arduino compatible module that lets you see what your Arduino is thinking using a built-in OLED ...
SPRK-CAB-11579
4.58€
61.03€
EasyVR is a multi-purpose speech recognition module designed to add versatile, robust and cost effective speech and voice recognition ...
28.99€
This non-contact infrared thermometer makes it a breeze to take quick and accurate surface temperature readings without getting too close ...
18.31€
This is a breakout board for Blackberry Trackball. The four spindles on the trackball have a tiny circular magnet the end; each of these ...
SPRK-PRT-12070
5.34€
This is the Solder-able Breadboard. A bare PCB that is the exact size as our regular breadboard with the same connections to pins and power ...
SPRK-COM-10438
53.40€
This is a thermal printer like you would find on a cash register or adding machine. It will print simple strings passed to it via TTL ...
11.44€
After turning on the device, the hot side will heat quickly, the cold side will cool quickly. If you do not remove the heat from the hot ...
SPRK-BOB-12009
2.29€
The SparkFun bi-directional logic level converter is a small device that safely steps down 5V signals to 3.3V AND steps up 3.3V to 5V at ...
SPRK-CAB-12613
9.55€
Description: This HDMI to VGA Adapter enables you to connect an HDMI port to a VGA port. These adapters are especiall
SPRK-CAB-09741
5.34€
32.04€
If you need a lot of inputs and/or outputs, this is your solution! The Mux (Multiplexer) Shield adds the capacity for up to 48 inputs or ...
SPRK-COM-09312
0.92€
Hall Effect Sensor US1881 in TO-92 package
6.48€
2.4GHz Duck Antenna 2.2dBi with Reverse Polarized - SMA RF connector. 50 ohm impedance. Long: 100mm.
SPRK-CAB-12977
12.21€
This is a USB to TTL Serial Cable which allows for a simple way to connect TTL interface devices to USB. The I/O pins of this cable are ...

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice