SparkFun Humidity Sensor Breakout - SHTC3 (Qwiic)

7.14 8.64 VAT included
Rated 0/5 (0 Votes!)
Model: SPRK-SEN-16467
Manufacturer: Sparkfun
Sparkfun
In Stock Available for immediate delivery

Looking to keep a log of the climate in your greenhouse, create a humidor control system or want to track temperature and humidity data for a weather station project? The SparkFun SHTC3 Humidity Sensor may be the perfect option for you! The SHTC3 is a low cost, easy-to-use, highly accurate digital humidity and temperature sensor. The SHTC3 communicates via I2C so, as you can tell by the name, we have broken out the pins on the sensor to Qwiic connectors so you can easily connect it to SparkFun's ever growing Qwiic Ecosystem.

The SHTC3 digital humidity sensor from Sensirion builds on the success of their SHTC1 sensor with a broader supply voltage range (1.62V to 3.6V) and higher accuracy (2% RH, 0.2C) than its predecessor, enabling greater flexibility. All you need are two lines for I2C communication, and you?ll have relative humidity readings and very accurate temperature readings as a bonus!

Hook up is a breeze as the breakout board is using the Qwiic connect system. The breakout board has built-in 2.2k? pullup resistors for I2C communications. If you?re hooking up multiple I2C devices on the same bus, you may want to disable these resistors.

NOTE: The I2C address of the SHTC3 is 0x70 and is hardware defined. A multiplexer/Mux is required to communicate to multiple SHTC3 sensors on a single bus. Sadly this is the same I2C address our Qwiic Mux uses and this part is not compatible with the Qwiic Mux.


The SparkFun Qwiic Connect System is an ecosystem of I2C sensors, actuators, shields and cables that make prototyping faster and less prone to error. All Qwiic-enabled boards use a common 1mm pitch, 4-pin JST connector. This reduces the amount of required PCB space, and polarized connections mean you can?t hook it up wrong.

The SHTC3 digital humidity sensor can also be automatically detected, scanned, configured, and logged using the OpenLog Artemis datalogger system. No programming, soldering, or setup required!


Features:

  • Uses I2C interface (Qwiic-enabled)
    • I2C Address: 0x70
    • 2x Qwiic Connectors
  • Operating voltage range
    • 1.62V - 3.6 V
    • Typically 3.3V if using the Qwiic cable
  • Relative Humidity
    • Operating range: 0% to 100%
    • Typical accuracy: 2 %RH
    • Resolution: 0.01 %RH
  • Temperature
    • Operating range: -40C to +125 C
    • Typical accuracy: 0.2 C
    • Resolution: 0.01 C
  • Typical current consumption (varies based on mode)
    • 4.9A to 430A (Normal Mode)
    • 0.5A to 270A (Low Power Mode)

Documents:

Videos

For more information, please visit this products webpage.
More products in this category:
Qwiic

Sparkfun Qwiic I2C »

SparkFun's Qwiic Connect System uses 4-pin JST connectors to quickly interface development boards with sensors, LCDs, relays and more.
Europe Official Distributor
Adafruit
Pololu
Sparkfun
Makey makey
Lilypad
Arduino
Seeedstudio
Qwiic

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice