RFID Reader Breakout

2.97 3.59€ VAT included
Rated 0/5 (0 Votes!)
Model: SPRKC-SEN-13030
Manufacturer: Sparkfun
Sparkfun

This is a simple breakout board for our RFID readers. The RFID Reader Breakout converts the 2mm pins to bread board friendly 0.1" headers. With this ability the ID-3LA, ID-12LA, and the ID-20LA you can solder the reader directly to the breakout board or use the 2mm sockets.

This breakout board’s edges actually fit flush within the under side the ID-12LA. The board also works with the ID-20LA, but is smaller than the edges. As stated before each pin of the RFID reader has been broken out including: VCC, READ, D0, D1, FORM, TIR, CP, both ANTs, RES, and GND. We’ve even added four half-mounting holes to the board to easily secure your project!

Documents:

For more information, please visit this products webpage.
More products in this category:

ID »

Europe Official Distributor
Adafruit
Pololu
Sparkfun
Makey makey
Lilypad
Arduino
Pimoroni
Categories
Manufacturers
Best Sellers
Producto
SPRK-DEV-13956
SparkFun Weather Shield
Producto
ELTN-050
Producto
ELTN-051

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice