Photo Transistor Light Sensor

1.46 1.77€ VAT included
Rated 0/5 (0 Votes!)
Model: ADFC-2831
Manufacturer: Adafruit
Adafruit

This Photo Transistor Light Sensor is a simple sensor that detects ambient light. It's kind of the opposite of an LED - when light hits the little chip inside, it induces current to flow from the long pin to the short pin. This sensor has a built-in optical filter (probably IR filter) so it'll do a fair job of simulating light levels as the human eye does.  Basically, connect the pin connected to the 'thicker' part of the sensor to 3-15VDC or so, and the thinner-part pin through a ~1K-10K series resistor to ground. When its dark, there's almost no current flowing through the sensor or resistor and the analog voltage is near ground. When there's light near the sensor, the current through the resistor will increase, raising the voltage. You can adjust the series resistor to get the voltage range you need, and measure the analog voltage with a microcontroller. If you're not getting any readings, try flipping the sensor around.

These are, essentially, replacements for CdS photocells, but are RoHS compliant.

For more information, please visit this products webpage.
More products in this category:
Europe Official Distributor
Adafruit
Pololu
Sparkfun
Makey makey
Lilypad
Arduino
Seeedstudio
Qwiic

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice