MI:pro Protector Case for micro:bit

7.17 8.68 VAT included
Rated 0/5 (0 Votes!)
Model: SPRKC-PRT-14680
Manufacturer: Sparkfun
Sparkfun

The MI:pro Protector is a simple and compact protective case for the micro:bit. These cases feature a four-layer construction style with ability to mount a 2xAAA battery pack to the back of the case while still providing access to all buttons and ports on the micro:bit. Though these cases do protect the micro:bit astoundingly well, the biggest benefit of using the MI:pro is to not accidentally short out the pads on the back of the micro:bit.

Construction is simple, requiring only a small flathead screwdriver (at most), and involves layering each plate on top of one another around the micro:bit and screwing it into place. Luckily, the MI:pro Protector case enables easy access to the edge pins at the bottom of the micro:bit, allowing it to still be plugged into an edge connector found on many of our carrier boards. The only board that cannot be used in conjunction with the MI:pro case is the SparkFun gamer:bit due to its edge connector being located in the center of the board.

Note: The MI:pro Protector case only includes the parts found in the Includes Tab. This case does NOT include a micro:bit, power source or mounting screws. These items will need to be purchased separately.

Includes:

  • 1x Front Plate
  • 1x Back Mounting Plate
  • 1x Mid-Layer Screw Hole Plate
  • 2x Mid-Layer Plate
  • 1x Counter Sunk M3 8mm Screw
  • 4x M3 Nylon Machine Screw
  • 5x M3 Nylon Full Nut

Documents:

Videos

For more information, please visit this products webpage.
More products in this category:
Europe Official Distributor
Adafruit
Pololu
Sparkfun
Makey makey
Lilypad
Arduino
Seeedstudio
Qwiic

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice