L298 Dual H-Bridge Motor Driver

21.50 26.02 VAT included
Rated 4.5/5 (8 Votes)
Model: SEE-105990007
Manufacturer: Seeedstudio
Seeedstudio
Double H driver module uses ST L298N dual full-bridge driver, an integrated monolithic circuit in a 15- lead Multiwatt and PowerSO20 packages. It is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors. Two enable inputs are provided to enable or disable the device independently of the input signals. The emitters of the lower transistors of each bridge are connected together and the corresponding external terminal can be used for the con-nection of an external sensing resistor. An additional supply input is provided so that the logic works at a lower voltage.

- Light weight, small dimension
- Super driver capacity
- FWD protection
- Heavy load Heat sink
- 2 current probe port
- Power selection switch
- 4 pull up resistor switch
- 2 DC motor/ 4 coil dual phrase stepper motor output
- Motor direction indication LED
- 4 standard mouting hole

Spec:

● Driver: L298
● Driver power supply: +5V~+46V
● Driver Io: 2A
● Logic power output Vss: +5~+7V (internal supply +5V)
● Logic current: 0~36mA
● Controlling level: Low -0.3V~1.5V, high: 2.3V~Vss
● Enable signal level: Low -0.3V~1.5V, high: 2.3V~Vss
● Max power: 25W (Temperature 75 celsius)
● Working temperature: -25C~+130C
● Dimension: 60mm*54mm
● Driver weight: ~48g
● Other extensions: current probe, controlling direction indicator, pull-up resistoer switch, logic part power supply.

More products in this category:
Europe Official Distributor
Adafruit
Pololu
Sparkfun
Makey makey
Lilypad
Arduino

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice