KittenBot Silicone Sleeve for micro:bit

8.37 10.13€ VAT included
Rated 0/5 (0 Votes!)
Model: ADFC-3773
Manufacturer: Adafruit
Adafruit

This is possibly the cutest, angriest cat face we've ever seen. Even better, the KittenBot Silicone Sleeve protects and accessorizes your micro:bit board! 

The silicone is super soft yet has enough stretch to snugly fit on your board without fear of tearing, and the white bottom "bumper" slips on very securely when you don't want to plug your micro:bit into our DragonTail breakout. The rubber over the LED matrix is very thin, so the red LEDs will shine through when they're lit.

Also, the kitten ears on this charming little case can also turn your micro:bit into a wearable, so you can tote around your adorable, blinky micro:bit.

Available in a range of colors!

For more information, please visit this products webpage.
More products in this category:

Buy Adafruit Europe Official Distributor »

More Featured Products
Micro Servo SG90 9g
This is the most mini servo. Only weights 9 gram and gives you a 1.6kg.cm torque. Pretty strong regarding its size. General specifications - No load speed: 0.12 seconds / 60 degrees (4.8V) - Stall Torque: 1.6 kg / cm ...
4.70€
Vacuum Pump - 12V
Description: This vacuum pump really sucks! This pump operates at 12V and has enough suction for most small projects. We even used one to make our very own ...
16.78€
LilyPad Arduino USB - ATmega32U4 Board
The LilyPad Simple just got a whole lot… simpler. We’ve updated the Simple board to create the LilyPad USB by replacing the classic ATMega328 with the new ATMega32U4. Not only does that mean that it’s running a variation of the latest ...
24.71€
NodeMCU V3 IOT ESP8266 development kit
The NodeMcu is an open-source firmware and development kit that helps you to Prototype your IOT product within a few Lua script lines. Features: Open-source Interactive Programmable Low ...
5.75€
40 Pin Female-Female Splittable Jumper Wire 200mm
This is a splittable 40 pin 200mm length jumper wire for ...
2.87€
LilyPad Coin Cell Battery Holder - Switched - 20mm
Sure, your flashing, chip-tune playing T-shirt is really cool at the party… but at some point you need to turn it off. And yes, you could just pull the battery, or maybe you’ve even sewn a LilyPad slide switch in-line. Wouldn’t it be ...
2.23€
70:1 Metal Gearmotor 37Dx70L mm with 64 CPR Encoder
This gearmotor is a powerful 12V brushed DC motor with a 70:1 metal gearbox and an integrated quadrature encoder that provides a resolution of 64 counts per revolution of the motor shaft, which corresponds to 4480 counts per revolution of ...
33.29€
Europe Official Distributor
Adafruit
Pololu
Sparkfun
Makey makey
Lilypad
Arduino

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice