Adjustable Angle Support for 2020 Aluminum Extrusion

11.99 14.51€ VAT included
Rated 0/5 (0 Votes!)
Model: ADFC-1257
Manufacturer: Adafruit
Adafruit

This is an interesting hardware piece addition for 20x20 aluminum extrusion. Rather than being a 90 degree type plate, its a hinged piece that connects the end of one extrusion to the side of another, but with any angle you wish. You can loosen/tighten the angle with the screw on the side. Given its just a bolt, it's not incredibly strong so while you can use it for structure, its not a load-bearing connector: make sure there isn't a lot of torque on the joint. You can use thread-lock to make it stronger.

The half that connects to the side one an extrusion simply uses a single M4 or M5 x 8mm long screw + T-nut as you'd use with any other plate. For the half that connects to the end of an extrusion, you'll need to tap the 5mm diameter center-hole of the extrusion and screw directly in. We don't include a tap or matching screw so you'll want to pick those up from a hardware store.

//www.youtube.com/embed/7g57wRkY7Eo?rel=0&start=907&autoplay=0

Adjustable Angle Support for 2020 Aluminum Extrusion (15:07)

For more information, please visit this products webpage.
More products in this category:

Buy Adafruit Europe Official Distributor »

More Featured Products
Flex Sensor Sparkfun
A simple flex sensor 2.2" in length. As the sensor is flexed, the resistance across the sensor increases. The resistance of the flex sensor changes when the metal pads are on the outside of the bend (text on inside of ...
7.95€
Conductive Thread - 60g (Stainless Steel)
Description: This is about 360 yards of conductive thread spun from stainless steel fiber and wound on a spool. You can use it as a creative way to connect various electronics onto clothing projects. This large spool ...
52.52€
LilyPad Coin Cell Battery Holder - Switched - 20mm
Sure, your flashing, chip-tune playing T-shirt is really cool at the party… but at some point you need to turn it off. And yes, you could just pull the battery, or maybe you’ve even sewn a LilyPad slide switch in-line. Wouldn’t it be ...
2.23€
Breadboard White Self-Adhesive
Dimensions: 8.2x5.5cm Self-adhesive on the ...
5.49€
Lithium Ion polymer Batteries 6A
This is a light weight, high energy density Lithium Ion polymer battery. It outputs a nominal 3.7v at 6000mAh, comes terminated with a standard 2-pin JST connector- 2mm spacing between pins. Features: Excellent long-term ...
22.95€
Europe Official Distributor
Adafruit
Pololu
Sparkfun
Makey makey
Lilypad
Arduino

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice