Adafruit On Demand

Displaying 1 to 100 (of 1006 products)
VAT not included
17.85
High-conductive heating fabrics are so hot right now!
7.38
Not just a simple breakout board, this microSD adapter goes the extra mile - designed for ease of use.Onboard 5v->3v regulato
2.90
These pretty strips of light are plastic diffused backlights, often seen in LCD displays. Normally they're tucked behind the LCD and ...
3.89
This conductive material (also known as "Velostat" or "Linqstat") is a nice addition for your wearable/sensor hacking toolkit. It's ...
13.73
The datasheet for the DS3231 explains that this part is an "Extremely Accurate I²C-Integrated RTC/TCXO/Crystal". And, he
ADF-261
0.74
Red and black tinned wires with a 2-pin JST PH connector on the end. 4" / 100mm long. Matches up nicely with our Lipoly charger!
19.63
These displays are small, only about 1.3" diagonal, but very readable due to the high contrast of an OLED display. This display is made ...
13.73
Sensiron Temperature/Humidity sensors are some of the finest & highest-accuracy devices you can get. And, finally we have some that have ...
7.82
Add an ear to your project with this well-designed electret microphone amplifier with AGC. This fully assembled and tested board comes ...
5.86
A really tiny portable inverter for EL wire. Powers off of a single CR2032 coin battery (not included!), it can drive up to 50cm / 20 ...
2.90
What do you get when you power a layer of liquid crystal material sandwiched between two sheets of glass? A Liquid Crystal Light ...
7.38
What do you get when you power a layer of liquid crystal material sandwiched between two sheets of glass? A Liquid Crystal Light ...
34.39
If you've ever ordered and wire up a 9-DOF sensor, chances are you've also realized the challenge of turning the sensor data from an ...
14.71
You want to make a cool robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts. Or maybe you want to ...
1.92
These pretty strips of light are plastic diffused backlights, often seen in LCD displays. Normally they're tucked behind the LCD and ...
5.90
The classic 'third hand tool,' as seen on every desk! We have one next to our Panavise jr, the
12.23
Add even more power to your robot with this metal-geared servo. The tiny little servo can rotate approximately 180 degrees (~90 ...
12.30
We sure love the ATmega328 here at Adafruit, and we use them a lot for our own projects. The processor has plenty of GPIO, ...
4.43
Get that heat sink stuck on good and strong with 3M's thermal tape. Specifically designed for attaching heat sinks to ICs. Works better ...
5.86
This is a great battery-backed real time clock (RTC) that allows your Raspberry Pi project to keep track of time if the power is lost. ...
6.84
It's summer and you're sweating and your hair's all frizzy and all you really want to know is why the weatherman said this morning that ...
44.23
Yes, this is an adorable small television! The visible display measures only 2.5" (6.35cm) diagonal, the TFT comes with a NTSC/PAL ...
27.50
Put on your sunglasses before putting this shield onto your 'duino - 40 eye-blistering RGB LEDs adorn the NeoPixel shield for a blast of ...
7.87
Need some really bright LEDs? We are big fans of these clear green LEDs, in fact we use them exclusively in our kits. They are very ...
5.86
Add some steely elegance to your project with these Metal Ball Tactile Buttons. They've got a nice industrial shine to t
14.71
This lovely little display breakout is the best way to add a small, colorful and bright display to any project. Since the display uses ...
2.90
Never get frustrated with 2mm-pitch modules again! Each one of these 40-pin break-apart header packs contains 5 pieces o
7.38
Round and round and round they go! 12 ultra bright smart LED NeoPixels are arranged in a circle with 1.5" (37mm) outer diameter. The ...
6.84
Break seals! Void warranties! With this handy Torx driver set at your hands, all hardware you touch will open up and reveal their secret ...
29.47
Feather is the new development board from Adafruit, and like its namesake it is thin, light, and lets you fly! We designed Feather to be ...
1.92
This brilliant invention is a blessing for makers designing or using boards with standard 2.1mm DC barrel jacks. Many devices opt ...
2.46
One truth about working with audio is you always need the cable or adapter you don't have in your toolbox. That's why we love ...
2.90
Make a small linear display with a glowing white color using this elegant LED bargraph. Only 1" long, it is quite visible but not so ...
19.63
This new Adafruit shield makes it easy to use a 16x2 Character LCD. We really like the Blu
1.92
Turn a wall adapter into a mini power supply with this incredibly useful adapter. A high quality molded 2.1mm DC barrel jack is brought ...
8.36
This is the FeatherWing Tripler - a prototyping add-on and more for all Feather boards. This is similar to our
ADFC-3197
30.66
Are you still looking for that perfect PCB holder? The low profile PCB Stickvise might be just the thing you need!
24.55
Blinded by the light? Tell "The Boss" not to worry, especially with this
8.81
Your wearable can now keep you from getting sunburnt, with the Flora digital UV index sensor.
3.89
*Ka-thunk* Pin down that PCB with our Toggle Clamp, a sturdy and reliable way to quickly press and release with precisio
19.39
You have some frickin' sharks at your lair, and you're thinking "it would be really great if I could attach some lasers to them" and ...
60.37
These panels come to us from Voltaic Systems, makers of fine solar-powered bags and packs. These are waterproof, scratch resistant, and ...
4.87
This little remote control would be handy for controlling a robot or other project from across the room. It has 21 buttons and a layout ...
1.92
This Panel Mount 10K Dual Logarithmic Potentiometer w/ On-Off Switch is a two-in-one; you get a dual-ganged potentiomete
2.46
One truth about working with audio is you always need the cable or adapter you don't have in your toolbox. That's why we love ...
2.90
This cable will let you swap out the stock 150mm long flex cable from a Raspberry Pi Camera (either 'classic' or 'NoIR' type) or ...
9.79
We just love this little 1.8" TFT display, with true TFT color (up to 18-bits per pixel!), fine 160x128 resolution, two white LED ...
4.87
This woven conductive fabric is silver colored and made of Copper+Nickel-plated nylon. Use small pieces for soft switches, plush ...
9.79
One segment? No way dude! 7-Segments for life!This is the Green Adafruit 0.56" 4-Digit 7-Segment Display w/ FeatherWing Co
4.87
This is the Custom Gamepad PCB for the PiGRRL 2 pack! The board is
9.79
This pressure sensor from Freescale is a great low-cost sensing solution for precision measurement of barometric pressure and altitude. ...
2.46
This 4" / 100mm long flexible uFL 2.4GHz antenna has approx 4DBi gain and a 50Ω impedance so it will work fantastic
24.55
Metro is our series of microcontroller boards for use with the Arduino IDE. This new Metro M0 Express board looks a whol
9.35
What is better than smart RGB LEDs? Smart RGB+White LEDs! These NeoPixel rings now have 4 LEDs in them (red, green, blue and ...
3.89
Sew a little sparkle into your wearable project with an Adafruit LED Sequin. These are the kid-sister to our popular
14.71
FLORA is Adafruit's fully-featured wearable electronics platform. It's a round, sewable, Arduino-compatible microcontroller designed to ...
24.55
With a slip ring assembly, your electronics can now twist and turn safely. Add wheel encoders, 360 degree sensors, rotating LEDs, rotors ...
10.78
You wont be able to look away from the mesmerizing patterns created by this Adafruit 15x7 CharliePlex LED Matrix Display FeatherW
9.79
"You see, wire telegraph is a kind of a very, very long cat.  You pull his tail in New York and his head is meowing in Los Angeles.  ...
6.84
Oh so handy, this little lipo charger is so small and easy to use you can keep it on your desk or mount it easily into any project! ...
14.71
This touch-able add on HAT for Raspberry Pi will inspire your next interactive project with 12 capacitive touch sensors. Capacitive ...
4.87
Your microcontroller probably has an ADC (analog -> digital converter) but does it have a DAC (digital -> analog converter)??? Now it ...
9.79
It looks like a micro servo, it acts like a micro servo, but it's more than just a micro servo! We got a factory to custom-make these ...
3.89
If you've got a resistive touch screen that you'd like to use, you'll need this breakout! It has a fine pitch (0.5mm) connector soldered ...
35.18
Are you ready? Really ready? Cause here comes the fastest, most powerful Metro ever. The Adafruit Metro M4 featuring the
34.39
Have some USB logic analyzer, multimeter or oscilloscope and bumping up against the frustration of a shared earth ground? ...
78.67
For those who want to take it to the next level we now have a 3G Cellular Modem breakout! The FONA 3G has better coverage, GSM ...
ADFC-1660
1.92
Add tons of storage to your next project with this micro SD card socket. We use this part in all our designs and it works great with any ...
24.55
This is a fancy upgrade to standard 20x4 LCDs, instead of just having blue and white, or red and black, this LCD has full color RGB ...
8.81
A Feather board without ambition is a Feather board without FeatherWings! This is the Adalogger FeatherWing: it adds bot
5.86
These are 9x16 Charlieplexed LEDs designed to match with the Adafruit 16x9 Charlieplexed
0.93
Make your own USB connections without slicing apart a USB cable and soldering those thin wires inside. This is the 'slim' version of the ...
29.47
It's a mini HDMI decoder board! So small and simple, you can use this board as an all-in-one display
34.44
Introducing the MENTA, a portable minty Arduino-compatible project that fits into a common mint tin. We took our super popular Boarduino ...
4.87
Quadruple your power adapters with this wonderfully simple 4-way power jack splitter. All you have to do is connect a standard ...
21.60
Aww yeah, it's the Feather you have been waiting for, and now with stacking headers! The HUZZAH32 is ou
9.79
Add short-hop wireless to your Feather with these RadioFruit Featherwings. These add-ons for any Feather board will let you integrate ...
15.30
This is an extra large proto-shield, specifically designed for the Mega! It comes with PCB, two buttons and a full set of stacking ...
0.74
Silicone-sheathing wire is super-flexible and soft, and its also strong! Able to handle up to 200°C and up to 600V, it will do when PVC ...
1.99
These Silicone Tubes are replacements for your fancy professional silic
63.96
Read wireless heart-rate data into your electronics projects in under 10 minutes with this educational experimentation kit for Polar ...
34.39
So, you want lots and lots of NeoPixels? And you want them for less? Not a problem! Here's a sheet of Flora NeoPixels fresh from the ...
2.95
Breakaway header is like the duct tape of electronics, and this header is one better with extra long pins on both sides. This ...
2.90
This wire is flexible, strong, and super easy to solder, too!Stranded core wire is best used for wiring jigs where theres bending ...
21.60
Make your robot or CNC move on our 15mm Supported Slide Rail with this sliding ball-b
1.92
This 'shorty' 2x20 header is great for a slim connection to your Raspberry Pi model A+ or B+, it's basically the  through-hole version ...
5.86
This breakout board is the simplest way to create a project with a single "toggle" capacitive touch sensor. No microcontroller is ...
ADFC-124
17.22
Drawdio is an electronic pencil that lets you make music while you draw! It's great project for beginners: An easy soldering kit with ...
17.22
Thermocouples are very sensitive, requiring a good amplifier with a cold-compensation reference, as well as calculations to handle any ...
11.76
What's better than a single LED? Lots of LEDs! A fun way to make a small display is to use an
19.63
Add motion, direction and orientation sensing to your wearable FLORA project with this high precision 9-DOF sensors. Inside are three ...
2.90
Better grab your sunglasses, your sunscreen, and a bucket hat because this 3W RGB LED is so brig
2.90
Having difficulty attaching a PCB? This kit is especially useful when there are no mounting holes - as with the original Raspberry Pi. ...
17.90
Ever go to a diner and they give you a bottle of ketchup and it says "Extra Fancy" and you're thinking to yourself "what makes this ...
3.89
When soldering small surface-mount (SMD/SMT) components, one thing you'll need is a good pair of tweezers. These are a great pair of ...
19.63
Say hello to our 0.96" 160x80 Color TFT Display w/ MicroSD Card Breakout – we think it's T-F
19.63
What is better than smart RGB LEDs? Smart RGB+White LEDs! These NeoPixel rings now have 4 LEDs in them (red, green, blue and ...
9.79
The biggest NeoPixel Ring yet! With four of these you can make a huge ring with 60 ultra bright smart LED NeoPixels are arranged in a ...
7.82
Put a voltage meter anywhere with this very handy display. These are often used by RC hobbyists for keeping track of batteries but we ...

Electan uses cookies for the operation of the website, monitoring site performance and to deliver interest based content.

Accept & Close

See privacy notice